Freestanding Baths – Considerations When Choosing and Fitting a Waste Kit

Plug and Chain, Click Clack or Pop Up Waste
There are three basic types of waste kit. The original plug and chain waste is known to everyone. A retainer plug and chain waste is but one where the plug fits into the overflow grill when not in use to keep against each other of methods. Plug and chain wastes usually come with sometimes a ball chain or perhaps a link chain. Most plug and chain wastes will fit most freestanding baths. A click clack waste is but one which has a sprung plug which operates like many contemporary basin wastes, you push the plug in also it clicks shut, push it again to click it open, with click clack wastes a chrome cover fits within the overflow hole but stands slightly happy with it in order to not block it. A pop up waste is but one that’s controlled with a chrome dial which fits within the overflow, a cable works on the outside of the bath from the dial for the plug and turning the dial causes the cable to move and operate the plug. Most click clack and pop up waste purchased in major chains is not going to fit most traditional freestanding roll top baths.


Concealed or Exposed Waste Kit
A low profile waste kit is but one that’s assumed to be fitted in circumstances where solely those parts which can be fitted in the bath will be seen, in order that all the pipe work outside the bath – the overflow pipe, trap and outlet pipe can be plastic. An exposed waste kit is metal/chrome without plastic parts and is all made to be observed. A regular double ended freestanding bath if placed pretty much against a wall can be fitted which has a concealed waste kit as the pipework will be hidden between the bath as well as the wall. Just one ended traditional freestanding bath will most likely have all the pipework visible when viewed in profile wherever you install it so for these and then for double ended baths which can be outside the wall you’d probably fit an exposed waste kit which has a chrome trap and outlet pipe.

Thickness of Freestanding Baths
Most traditional Freestanding Baths less complicated thicker than standard panel baths which may cause an issue with many waste kits. All waste kits use a parts that sit down on each side in the plug and overflow holes and repair together to form a sandwich structure with all the wall in the bath is the sandwich filling and areas of the waste kit on each side. For plug and chain wastes the various in the waste kits generally connect to a threaded bolt to be able long since the bolts are long enough (which they are often) then these kits will fit on any thickness of overflow or plug hole. However most click clack and pop up wastes use instead of a bolt an extensive bore plastic threaded tube which may be only 7 to 12 mm thick, this is not hick enough for most traditional roll top baths.

Fitting a Trap to some Freestanding Bath
Freestanding baths either with or without feet often have reduced clearance under the bath along with a standard size bath trap might not exactly fit between the bath as well as the floor. If you can to enter a floor under the bath then the hole can be made inside the floor to the trap to adjust to into, adhere to what they your floor is concrete or of for aesthetic reasons you can’t enter the floor then you will have to have a shallow or ultra shallow bath trap that you should get from your specialist.
More details about Freestanding Baths view our site: here

Leave a Reply